Seeds trajectories in horizontal duct of an air drill seeder
DOI:
https://doi.org/10.5944/ribim.16.1.42500Keywords:
Pneumatic conveying, Simulation, Two-phase flow, One way couplingAbstract
The pneumatic conveying of grains is widely known. In the particular case of "air drill" seeders, hoses are used to transport seeds and / or fertilizer from the storage hopper to the distributor, and finally to sowing units. A typical problem in this type of conveyors is the accumulation of seeds in troubled sectors of the system, eg in direction changes or sudden changes in pipe section (reduction or increase). In this work, trajectories of the seeds in a horizontal duct, and the influence of the forces acting on them, are analyzed using numerical simulation. The fluid is modeled by Navier Stokes equations, using a solving technique of Reynolds Average Navier-Stokes standard (RANS), with the turbulence model k-ε. The particles studied are soybeans, which are
considered as rigid spheres of uniform size. The particle-air mixture is considered as a dilute phase flow, using a weak coupling between both phases. A Lagrangian approach is applied to the particles, while fluid is treated with an Eulerian approach.
Downloads
Downloads
Published
How to Cite
Issue
Section
License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Los autores conservan los derechos de autor y ceden de forma no exclusiva los derechos de explotación de los trabajos aceptados para su publicación en Revista Iberoamericana de Ingeniería Mecánica, garantizan a la revista el derecho de ser la primera publicación del trabajo.
Los autores permiten que la revista distribuya los trabajos publicados bajo la licencia de uso Creative Commons Atribución-NoComercial-SinDerivadas 4.0 Internacional (CC BY-NC-ND 4.0 International). Esta licencia permite a otros compartir el trabajo con un reconocimiento de la autoría del trabajo y de la publicación inicial en esta revista. Se puede copiar, usar, difundir, transmitir y exponer públicamente, siempre que: i) se cite la autoría y la fuente original de su publicación (revista, editorial y URL de la obra); ii) no se use para fines comerciales.
Se permite y se anima a los autores a difundir electrónicamente (en un repositorio institucional, etc) la versión publicada del artículo (VOR) siempre con referencia a su publicación en la Revista Iberoamericana de Ingeniería Mecánica.
La publicación en esta revista es gratuita y no impone ningún coste a los autores.