Experimental measurements of thermal hydraulic parameters in the core of nuclear research reactor

Abstract

The IPR-R1 is a 250 kWth TRIGA light-water and open pool type research reactor. The IPR-R1 is located at the Nuclear Technology Development Centre - CDTN (Belo Horizonte/Brazil), a research institute of the Brazilian Nuclear Energy Commission - CNEN. The core has an annular configuration of six rings and is cooled by natural circulation. The core coolant channels extend from the bottom grid plate to the top grid plate. The cooling water flows through the holes in the bottom grid plate, passes through the lower unheated region of the element, flows upwards through the active region, passes through the upper unheated region, and finally leaves the channel through the differential area between a triangular spacer block on the top of the fuel element
and a round hole in the grid. Direct measurement of the flow rate in a coolant channel is difficult because of the bulky size and low accuracy of flow meters. The flow rate through the channel may be determined indirectly from the heat balance across the channel using measurements of the water inlet and outlet temperatures. This paper presents the experiments performed in the IPR-R1 reactor to monitoring some thermo-hydraulic parameters in the core coolant channels, such as: the radial and axial temperature profile, temperature, velocity, mass flow rate, mass flux and Reynolds’s number. Some results were compared with theoretical predictions, as it was expected the variables follow the power distribution (or neutron flux) in the core.